11/24/2023 0 Comments Making a homemade incubatorOnce the humidity drops below 50%, and the humidity controller turns on the humidifier, it only takes a couple minutes to bring it back up to 55%.Ī ¼” hole in the center of top handhold of cooler for tube to fit through. I think the incubator gets up to 99.5 degrees in 4 to 5 minutes. It’s just two metal plates ¼” apart in aīakelite tube and starts to steam in 30 seconds. I got a 3/16” nylon barb splice ($1) and cut the barbs off one end. That has been sitting on a night stand in my childhood bedroom since I was Looked around for a humidity supply and chose the Hankscraft humidifier I added two soaked sponges.Ĥ8.8% is all the sponges could do so I have to add more water. My humidity dropped from 65% to 29.8% at 99.5 degrees. And I had to raise the temperature controller calibration +2 degrees. I had to adjust the humidity controller calibration to +6 to get the right You can buy a Wet Bulb / Dry Bulb Hygrometer to test your relative humidity. You just wrap a regular thermometer bulb with gauze, Sling Psychrometer works instantly just like one of these $40 Bacharach Local weather said 64% my Sling PsychrometerĪ Sling Psychrometer has two thermometers. You need accurate dry and wet bulb thermometers, humidity chart,Īnd what local weather says. Through temperature controller with 14 gauge wire.Īnd test it. Black OEM fan and red from heat sink (5 amp) Black from heat sink to positive, white from OEM (originalĮquipment manufacturer) fan to positive. Outside the incubator for a Temperature (about $14.57 on Ebay) and Humidity Turning it upside down messes up the original shelf slots. The square hole in the shelf in the cooler was just a fanįasten to the top shelf a computer-power supply fan blowing toward the door. I added four 1 ¾” long, ¼” dowels to keep the egg cartons from sliding inside This prevents the chick/duckling from sticking to the shell. The angle is 45 degrees for each of the 2 directions it will Way to turn the eggs is turning the whole cooler, so you need to make cradle Of the heat sink fan for operation in heat mode. Turn cooler upside down and reverse the polarity Remove the door seal and make a latch shim to crack the door open. You can also find good deals on Craigslist for similar I decided to turn my decades-oldĬoleman Model 5640 cooler, that I know heats, into the incubator, spendingĪs little as possible. Creative and handy, you can make your own incubator!Īt all the other DIY (Do It Yourself) incubators on BYC (Then I looked at my cooler collection.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |